Solar · Error codes · Sunsynk
F34Sunsynk · ECCO single-phase hybrid SG05LP1
F34 on a Sunsynk ECCO single-phase hybrid SG05LP1: AC overload fault
Short answer
On a Sunsynk inverter, F34 means: AC overload fault. The inverter stops until the fault clears or is reset.
Reviewed 24 September 2026 · 1 source
What it means
The manual says: AC overload fault.
Part involved: backup (load) output.
When it shows: Backup load exceeds rating.
Likely causes:
- AC load too heavy; wrong grid mode selected; inverter bridge fault.
Is it safe?
| Does the inverter stop? | Yes |
|---|---|
| Severity | Fault — clears by itself when the condition goes |
The inverter stops until the fault clears or is reset.
Resetting itself: yes.
Manual reset: Reduce load; seek help if persists.
What you can check
- Read the full code and message on the inverter screen or in the Sunsynk Connect app and note the date/time for your installer.
- Check the inverter's AC isolator next to the inverter and the solar/battery breaker in the consumer unit are ON (do not reset a breaker that trips again - call your installer).
- Switch off large appliances on backed-up circuits during an outage.
What the engineer will check
- Check backup load within rating; check grid mode setting.
Who to ask for: Qualified electrician / MCS PV installer.
Certification: Battery and hybrid-inverter DC work: installer trained/approved by the manufacturer; electrical work under BS 7671 by a competent person.
What you might notice
Sources
- Fault Codes Causes & Solutions Version 1.0 ↗ · Version 1.0 · page 8 · Reviewed 24 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 24 September 2026