AL11 on a MasterTherm heat pump: High Pressure Switch - compressor high discharge pressure from high pressure switch
Short answer
On a MasterTherm heat pump, AL11 means: High Pressure Switch - compressor high discharge pressure from high pressure switch. The heat pump stops until the fault clears or is reset. An engineer is needed to fix the cause. The wording differs by model range — each is shown below.
Reviewed 23 September 2026 · 1 source
What it means
On the pCO5/pGD controller alarms - air/water units (BoxAir, BoxAir Inverter, BoxAir Inverter P, AirMaster, EasyMaster)
The manual says: High Pressure Switch - compressor high discharge pressure from high pressure switch.
Part involved: high pressure switch.
When it shows: Control action: See AL01, AL02. Operator guidance: See AL01/AL02; always call service.
Likely causes:
- See AL01/AL02 (same causes as high pressure).
On the pCO5/pGD controller alarms - brine/water and water/water units (AquaMaster, AquaMaster Inverter, Inverter P, Combi)
The manual says: High Pressure Switch.
Part involved: high pressure switch.
When it shows: Control action: See AL01, AL02. Operator guidance: See AL01, AL02; always call service.
Likely causes:
- See AL01/AL02.
Is it safe?
| Does the heat pump stop? | Yes |
|---|---|
| Severity | Fault — clears by itself when the condition goes |
| Engineer needed? | Yes |
The heat pump stops until the fault clears or is reset.
Resetting itself: Resets automatically after the minimum compressor off time (~6 min) if the same alarm occurs fewer than 3 times per compressor operating hour.
Manual reset: After 3 occurrences in 1 compressor operating hour the unit is blocked (ALARM key lit steadily); manual reset by pressing ALARM key on the alarm display (pGD) or RESET on pGDx Alarm Management.
What you can check
- Read and note the alarm (ALx code/text) and the alarm counter shown on the pGD/pGDx display.
- Check the heat pump breaker/isolator in the consumer unit is on.
- Reduce requested heating water temperature.
What the engineer will check
On the pCO5/pGD controller alarms - air/water units (BoxAir, BoxAir Inverter, BoxAir Inverter P, AirMaster, EasyMaster)
- Check HP switch, water flow, filter, refrigerant circuit.
Who to ask for: heat pump service engineer (refrigeration/controls).
Certification: F-gas certification (refrigerant circuit work); electrical competence for switchboard work.
On the pCO5/pGD controller alarms - brine/water and water/water units (AquaMaster, AquaMaster Inverter, Inverter P, Combi)
- Check HP switch, flow and strainers.
Who to ask for: ground source heat pump engineer (refrigeration/controls).
Certification: F-gas certification (refrigerant circuit work); electrical competence for switchboard work.
What you might notice
Sources
- MasterTherm pCO5/pGD digital controller - OEM instruction manual, heat pumps AirMaster, AquaMaster, EasyMaster, BoxAir (Documentation PGD1-MANUAL, Edition 41, sw_11) ↗ · Edition 41 / sw_11 · pages 31, 42-43, 31, 40-41 · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026