Err33 on a Victron Energy SmartSolar / BlueSolar MPPT charge controllers: PV over-voltage
Short answer
On a Victron Energy inverter, Err33 means: PV over-voltage. The inverter stops until the fault clears or is reset. An engineer is needed to fix the cause.
Reviewed 24 September 2026 · 1 source
What it means
The manual says: PV over-voltage.
Likely causes:
- PV array open-circuit voltage configuration critical for this charger.
Is it safe?
Switch the inverter off at its isolator and call an engineer.
| Does the inverter stop? | Yes |
|---|---|
| Severity | Fault — clears by itself when the condition goes |
| Engineer needed? | Yes |
The inverter stops until the fault clears or is reset.
Resetting itself: yes - when PV voltage drops (often on cold bright mornings).
Manual reset: See Victron page.
What you can check
- Read the alarm/error number in the VRM portal or app, or on the GX touch/remote console, and note the time. Check the AC breakers feeding the system are ON. Victron's error pages say diagnosis is for trained professionals - pass the code and a VRM screenshot to your installer.
What the engineer will check
- Check array Voc at lowest expected temperature against the charger rating; re-organise panels.
Who to ask for: Victron-trained installer (Victron Professional).
Certification: MCS-certified solar PV installer (MIS 3002) or competent electrician (BS 7671 / Part P in England & Wales); DC work only by PV-trained installer.
What you might notice
Sources
- Victron Energy - MPPT Solar Charger Error Codes (live documentation) ↗ · live page retrieved 2026-09-24 · Reviewed 24 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 24 September 2026