ILeak-PRO01 on a Solis S6-EH1P L-PLUS 48 V hybrids: Leakage current failure 01 (30 mA); 02=60 mA, 03=150 mA
Short answer
On a Solis inverter, ILeak-PRO01 means: Leakage current failure 01 (30 mA); 02=60 mA, 03=150 mA. The inverter stops until the fault clears or is reset.
Reviewed 24 September 2026 · 1 source
What it means
The manual says: Leakage current failure 01 (30 mA); 02=60 mA, 03=150 mA.
Part involved: residual current.
Likely causes:
- Current leakage to ground; poor grounding; damaged wires.
Is it safe?
Switch the inverter off at its isolator and call an engineer.
| Does the inverter stop? | Yes |
|---|---|
| Severity | Fault — clears by itself when the condition goes |
The inverter stops until the fault clears or is reset.
Resetting itself: yes.
Manual reset: Restart; contact service if persists.
What you can check
- Read the full code and message on the inverter screen or in the SolisCloud app and note the date/time for your installer.
- Check the inverter's AC isolator next to the inverter and the solar/battery breaker in the consumer unit are ON (do not reset a breaker that trips again - call your installer).
What the engineer will check
- Check leakage to ground, grounding, wiring condition.
Who to ask for: MCS-certified solar PV installer (DC/string work) or the original installer.
Certification: Work on DC strings and inverter enclosures: competent PV installer (MCS-certified installer for warranty/SEG continuity); electrical work notifiable under Part P (England & Wales) or equivalent.
What you might notice
Sources
- User Manual for S6 Series Hybrid Inverter S6-EH1P(3-8)K-L-PLUS ↗ · Version 1.0 · page 54 · Reviewed 24 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 24 September 2026