Solar · Error codes · Solis
GRID-INTF02Solis · S6-EH1P L-PLUS 48 V hybrids
GRID-INTF02 on a Solis S6-EH1P L-PLUS 48 V hybrids: Power grid disturbance 02
Short answer
On a Solis inverter, GRID-INTF02 means: Power grid disturbance 02. The inverter stops until the fault clears or is reset.
Reviewed 24 September 2026 · 1 source
What it means
The manual says: Power grid disturbance 02.
Part involved: grid waveform.
Likely causes:
- Seriously distorted grid; loose AC cable.
Is it safe?
| Does the inverter stop? | Yes |
|---|---|
| Severity | Fault — clears by itself when the condition goes |
The inverter stops until the fault clears or is reset.
Resetting itself: yes.
Manual reset: Restart; contact service if persists.
What you can check
- Read the full code and message on the inverter screen or in the SolisCloud app and note the date/time for your installer.
- Check the inverter's AC isolator next to the inverter and the solar/battery breaker in the consumer unit are ON (do not reset a breaker that trips again - call your installer).
What the engineer will check
- Check grid distortion and AC cable.
Who to ask for: Qualified electrician / MCS PV installer.
Certification: None for homeowner checks; any grid-protection setting change needs installer and DNO consent (G98/G99).
What you might notice
Sources
- User Manual for S6 Series Hybrid Inverter S6-EH1P(3-8)K-L-PLUS ↗ · Version 1.0 · page 54 · Reviewed 24 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 24 September 2026