A11-1094 on a Worcester Bosch heat pump: No communication with ventilation unit
Short answer
On a Worcester Bosch heat pump, A11-1094 means: No communication with ventilation unit. The heat pump keeps running. An engineer is needed to fix the cause.
Reviewed 23 September 2026 · 1 source
What it means
The manual says: No communication with ventilation unit.
Part involved: ventilation unit link.
When it shows: No communication with ventilation unit.
Likely causes:
- Cabling fault.
Is it safe?
| Does the heat pump stop? | No |
|---|---|
| Severity | Warning |
| Engineer needed? | Yes |
The heat pump keeps running.
Resetting itself: Clears when cause removed.
Manual reset: CR 10 H manual: if a fault cannot be rectified note fault code and sub-code and contact contractor with ID no.
What you can check
- Read and note the full code (and sub-code) shown on the controller and pass it to your installer.
What the engineer will check
- Check cabling.
Who to ask for: heat pump installer / controls engineer.
Certification: None specific; electrical isolation required before wiring checks.
What you might notice
Sources
- CR 10 H room controller manual (multilingual) ↗ · 6720876740 (2017/08) · page 29 · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026