I.78 on a Viessmann One Base: Inverter current derating due to excessive power demand
Short answer
On a Viessmann heat pump, I.78 means: Inverter current derating due to excessive power demand. The manual does not say whether the heat pump stops.
Reviewed 23 September 2026 · 1 source
What it means
The manual says: Inverter current derating due to excessive power demand.
Part involved: Inverter current derating due to excessive power demand.
When it shows: System characteristics: Output reduction by inverter in the event of overheating due to current.
Likely causes:
- Output reduction by inverter in the event of overheating due to current.
Is it safe?
| Does the heat pump stop? | Not stated |
|---|---|
| Severity | Information only |
| Engineer needed? | No |
The manual does not say whether the heat pump stops.
Resetting itself: Not stated per code in Viessmann document 6199893 GB 01/2026 (VSA00009).
Manual reset: User may acknowledge via HMI after noting the code (6249162 p.57); the message returns if the cause persists.
What you can check
- On the HMI, tap the message and "?" to read the system characteristics and Viessmann's user tips; note the code (e.g. F.xxx) and text for your contractor (operating instructions 6249162 p.57).
- Acknowledge the message once via the HMI; do not acknowledge fault messages several times in quick succession (6249162 p.58) - notify your contractor.
- Check the heat pump breaker/isolator in the consumer unit is ON (do not repeatedly reset a breaker or RCD that keeps tripping).
What the engineer will check
- See Viessmann service instructions.
Who to ask for: Viessmann-trained heat pump engineer / qualified electrician.
Certification: Qualified electrician for work on electrical equipment (Viessmann safety instructions).
Sources
- Service instructions for contractors: Heat pumps in monoblock design incl. hybrid – System configuration and diagnostics (Vitocal 150-A/151-A/250-A/252-A, IDU-A, AWMOF-151/251, AquaSnap 30AWH, BI-BLOC R290) (6199893 GB 01/2026) ↗ · 6199893 GB 01/2026 (VSA00009) · page 219 · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026