F.430 on a Viessmann One Base: Communication error, gateway
Short answer
On a Viessmann heat pump, F.430 means: Communication error, gateway. The manual does not say whether the heat pump stops. An engineer is needed to fix the cause.
Reviewed 23 September 2026 · 1 source
What it means
The manual says: Communication error, gateway.
Part involved: Communication error, gateway.
When it shows: System characteristics: Operation with internal set value specifications of the heat pump control unit.
Likely causes:
- Gateway (WAGO KNX/TP) communication error.
Is it safe?
| Does the heat pump stop? | Not stated |
|---|---|
| Engineer needed? | Yes |
The manual does not say whether the heat pump stops.
Resetting itself: Not stated per code in Viessmann document 6199893 GB 01/2026 (VSA00009).
Manual reset: User may acknowledge via HMI after noting the code (6249162 p.57); the message returns if the cause persists.
What you can check
- On the HMI, tap the message and "?" to read the system characteristics and Viessmann's user tips; note the code (e.g. F.xxx) and text for your contractor (operating instructions 6249162 p.57).
- Acknowledge the message once via the HMI; do not acknowledge fault messages several times in quick succession (6249162 p.58) - notify your contractor.
- Check your home router/internet connection is working.
What the engineer will check
- Check system configuration for gateway: CAN bus subscriber number 90.
- Turn off the ON/OFF switch on the indoor unit. Wait at least 2 min. Turn on the ON/OFF switch.
- Check the CAN bus connections:.
- Connections X8.1 to X8.3 on plug 91 on the HPMU electronics module.
- Wall mounted indoor unit: Connection on device underside, 6-pole connection socket on the left, terminals 1.CAN L to 3.CAN H Floorstanding indoor unit: Terminal area ….
- Check wires and plugs for correct seating.
- Check connections for contact corrosion.
- Check cables for mechanical damage, e.g. crushing, kinking, chafing or breakage.
Who to ask for: Viessmann-trained heat pump installer/service engineer.
What you might notice
Sources
- Service instructions for contractors: Heat pumps in monoblock design incl. hybrid – System configuration and diagnostics (Vitocal 150-A/151-A/250-A/252-A, IDU-A, AWMOF-151/251, AquaSnap 30AWH, BI-BLOC R290) (6199893 GB 01/2026) ↗ · 6199893 GB 01/2026 (VSA00009) · page 131-132 · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026