F.1057 on a Viessmann One Base: Fault, high pressure sensor, refrigerant circuit
Short answer
On a Viessmann heat pump, F.1057 means: Fault, high pressure sensor, refrigerant circuit. The heat pump stops until the fault clears or is reset. An engineer is needed to fix the cause.
Reviewed 23 September 2026 · 1 source
What it means
The manual says: Fault, high pressure sensor, refrigerant circuit.
Part involved: Fault, high pressure sensor, refrigerant circuit.
When it shows: System characteristics: Heat pump off.
Likely causes:
- Fault, high pressure sensor.
Is it safe?
| Does the heat pump stop? | Yes |
|---|---|
| Engineer needed? | Yes |
The heat pump stops until the fault clears or is reset.
Resetting itself: Not stated per code in Viessmann document 6199961 GB 01/2026 (VSA00009).
Manual reset: User may acknowledge via HMI after noting the code (6249162 p.57); the message returns if the cause persists.
What you can check
- On the HMI, tap the message and "?" to read the system characteristics and Viessmann's user tips; note the code (e.g. F.xxx) and text for your contractor (operating instructions 6249162 p.57).
- Acknowledge the message once via the HMI; do not acknowledge fault messages several times in quick succession (6249162 p.58) - notify your contractor.
- Check the heat pump breaker/isolator in the consumer unit is ON (do not repeatedly reset a breaker or RCD that keeps tripping).
What the engineer will check
- Check voltage U on EHCU electronics module:.
- Terminals X20.1/X20.3: U = 5 V.
- Terminal X20.2: U = 0 to 5 V.
- Replace high pressure sensor if necessary.
Who to ask for: Viessmann-trained heat pump installer/service engineer.
What you might notice
Sources
- Service instructions: Heat pumps in split design incl. hybrid – System configuration and diagnostics (Vitocal 200-S/222-S One Base) (6199961 GB 01/2026) ↗ · 6199961 VSA00009 · page 166 · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026