Heat pumps · Error codes · Baxi
L0Baxi · HP40 / Baxi Assure HP50 Monobloc ASHP
L0 on a Baxi HP40 / Baxi Assure HP50 Monobloc ASHP: Module protection (P6 group)
Short answer
On a Baxi heat pump, L0 means: Module protection (P6 group). The heat pump stops until the fault clears or is reset. An engineer is needed to fix the cause.
Reviewed 23 September 2026 · 1 source
What it means
The manual says: Module protection (P6 group).
Part involved: inverter module, compressor, PFC.
Likely causes:
- Check heat pump system pressure; compressor phase resistance; U/V/W sequence; L1/L2/L3 connection to filter board; inverter board.
Is it safe?
| Does the heat pump stop? | Yes |
|---|---|
| Engineer needed? | Yes |
The heat pump stops until the fault clears or is reset.
Resetting itself: unknown.
Manual reset: Installer: correct cause then power OFF/ON (ISM 13.4).
What you can check
- Note the exact code shown on the controller and when it appeared.
- Check the outdoor unit is not blocked by leaves, debris, snow or covers and has clear airflow.
- Check the heat pump's consumer-unit breaker / isolator is on (do not open any panels).
- If the code persists or returns, contact a heat pump engineer.
What the engineer will check
- Check heat pump system pressure; compressor phase resistance; U/V/W sequence; L1/L2/L3 connection to filter board; inverter board.
Who to ask for: heat pump engineer with electrical competence.
Certification: Qualified electrician / manufacturer-trained heat pump engineer; F-gas if refrigerant circuit is opened.
What you might notice
Sources
- Installation and Service Manual - Heat Pump air/water 'inverter' HP40/50-4-1PHMB to HP40/50-13-3PHMB (United Kingdom) ↗ · 784570-01 (v1) · page 77 · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026