1017 on a Sigenergy SigenStor: Leak current out of limit. Official suggestion (summarised): Usually self-clears after environment stabilises; if frequent contact service
Short answer
On a Sigenergy inverter, 1017 means: Leak current out of limit. Official suggestion (summarised): Usually self-clears after environment stabilises; if frequent contact service. The inverter stops until the fault clears or is reset. An engineer is needed to fix the cause.
Reviewed 24 September 2026 · 1 source
What it means
The manual says: Leak current out of limit. Official suggestion (summarised): Usually self-clears after environment stabilises; if frequent contact service.
Likely causes:
- Leakage current above protection threshold.
Is it safe?
| Does the inverter stop? | Yes |
|---|---|
| Severity | Fault — clears by itself when the condition goes |
| Engineer needed? | Yes |
The inverter stops until the fault clears or is reset.
Resetting itself: no.
Manual reset: see notes.
What you can check
- Read the alarm code, name and ID in the mySigen app.
- Report it via mySigen app Support > Troubleshooting (Sigenergy's stated route) or contact your installer.
What the engineer will check
- Insulation checks on DC/AC.
- Sub-IDs: ID1.
Who to ask for: battery storage / PV inverter.
Certification: Sigenergy-trained installer; MCS PV/battery installer for certified installs; electrical work to BS 7671.
What you might notice
Sources
- Sigenergy Alarm List (Version 05) ↗ · 05 · Reviewed 24 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 24 September 2026