CC on a Viessmann Vitotronic 200: Coding card: Heat pump does not start

What it means

The manual says: Coding card: Heat pump does not start.

Part involved: Coding card.

When it shows: Heat pump does not start.

Likely causes:

• Coding card cannot be read.

Is it safe?

The manual does not say whether the heat pump stops.

Resetting itself: Not stated per code; Vitotronic messages remain until the cause is removed and are acknowledged with OK (6150133 p.82). Unremedied acknowledged faults are redisplayed the following day.

Manual reset: Acknowledge with OK on the programming unit (user level permitted per 5817913 p.56-57) after the cause is remedied.

What you can check

• Note the 2-character message code and message text shown on the Vitotronic 200 display (press OK for details) and give them to your heating contractor (operating instructions 5817913 p.56).
• You may acknowledge the message once with OK as described in the Vitotronic 200 operating instructions; if it reappears, do not keep acknowledging it - call your contractor.
• Check the heating system pressure gauge reading and report a low reading to your contractor; make sure the filling loop is closed.

What the engineer will check

• Check coding card: Switch off heat pump and check whether coding card has been inserted correctly; reinsert if necessary. Replace coding card if test was ….
• Check controller and sensor PCB and replace if necessary.

Who to ask for: Viessmann-trained heat pump installer/service engineer.

Sources

• Service instructions Vitotronic 200 type WO1C heat pump control unit (air/water split & monobloc, brine/water) (6150133, 2023-07) ↗ · 6150133 VSA00004 · page 105 · Reviewed 23 September 2026

A code explains what the controller detected, not a confirmed root cause.

Reviewed: 23 September 2026