8F on a Viessmann Vitotronic 200: Compressor drive deactivated
Short answer
On a Viessmann heat pump, 8F means: Compressor drive deactivated. The heat pump stops until the fault clears or is reset. An engineer is needed to fix the cause.
Reviewed 23 September 2026 · 1 source
What it means
The manuals for this range word it in different ways:
- Compressor drive deactivated.
- Inverter blocked.
- Vitocal 300-G/333-G: Inverter switched off.
- Inverter switched off.
Part involved: Compressor drive deactivated; Inverter blocked; Vitocal 300-G/333-G: Inverter switched off; Inverter switched off.
When it shows: Type "Fault" (S) - triggers "05 Refrigerant circuit" on the heat pump control unit. Heat pump characteristics: Compressor OFF.
Likely causes:
- Compressor drive deactivated.
- Inverter blocked.
- Vitocal 300-G/333-G: Inverter switched off.
- Inverter switched off.
Is it safe?
| Does the heat pump stop? | Yes |
|---|---|
| Engineer needed? | Yes |
The heat pump stops until the fault clears or is reset.
Resetting itself: Not stated in 6150133.
Manual reset: Refrigerant circuit messages cannot be acknowledged in the message history (6150133 p.155); acknowledge the resulting 05/07/A9 message on the control unit.
What you can check
- This code is only visible to engineers in the service menu (Diagnosis > Refrigerant circuit > Message history); homeowners see message 05, 07 or A9 - note that code and call your contractor.
What the engineer will check
- Check jumpers on inverter, terminals 4 to.
- Observe the connection and wiring diagram for the heat pump: See "EEV PCB [2] ".
- Replace inverter if necessary.
- Switch OFF the power supply to the outdoor unit. Wait at least 2 min. Switch the power ON again. Replace inverter if the fault persists.
- Check electrical connecting cable between inverter and compressor. Replace the connecting cable if necessary: See "Connection and wiring diagram".
- Check Modbus connecting cable, inverter — EEV PCB.
Who to ask for: Viessmann-trained heat pump engineer with F-gas refrigeration certification.
Certification: F-gas certificate (UK F-gas Regulations; Viessmann: refrigerant work by authorised refrigeration engineers only).
What you might notice
Sources
- Service instructions Vitotronic 200 type WO1C heat pump control unit (air/water split & monobloc, brine/water) (6150133, 2023-07) ↗ · 6150133 VSA00004 · pages 159, 170, 177, 164 · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026