E08 on a Toshiba heat pump: Duplicate address of hydro unit / duplicate master in group control
Short answer
On a Toshiba heat pump, E08 means: Duplicate address of hydro unit / duplicate master in group control. The heat pump stops until the fault clears or is reset. An engineer is needed to fix the cause. The wording differs by model range — each is shown below.
Reviewed 23 September 2026 · 3 sources
What it means
On the R32 Estia 1-Series (split, Wall-Mounted and All-in-One)
The manual says: Duplicate address of hydro unit / duplicate master in group control.
Part involved: DIP switches, DN/FC codes, addresses, model combination.
When it shows: Group control address conflict.
Likely causes:
- Hydro address DN 12-14 set incorrectly.
On the Estia 5 Series (Standard)
The manual says: Duplicate address of hydro unit / duplicate master (group control).
Part involved: DIP switches, DN/FC codes, addresses, model combination.
When it shows: Address conflict.
Likely causes:
- Rotary switch SW01 address.
On the Estia 5 Series Powerful (Hi Power / Extreme)
The manual says: Duplicate address of hydro unit / duplicate master (group control).
Part involved: DIP switches, DN/FC codes, addresses, model combination.
When it shows: Trigger thresholds not printed in the IM; see SM.
Likely causes:
- Rotary switch SW01 address.
Is it safe?
| Does the heat pump stop? | Yes |
|---|---|
| Severity | Fault — clears by itself when the condition goes |
| Engineer needed? | Yes |
The heat pump stops until the fault clears or is reset.
Resetting itself: yes (per manual).
Manual reset: Clear the code from the remote controller once the cause is fixed (service procedure).
What you can check
- Note the check code shown on the remote controller and the outdoor/hydro model numbers before contacting an engineer.
What the engineer will check
On the R32 Estia 1-Series (split, Wall-Mounted and All-in-One)
- Follow manufacturer's check-code flowchart.
- Hydro address DN 12-14 set incorrectly.
Who to ask for: Installer / commissioning engineer (Toshiba Estia).
Certification: Manufacturer training advantageous.
On the Estia 5 Series (Standard)
- Follow manufacturer's check-code flowchart.
- Rotary switch SW01 address.
Who to ask for: Installer / commissioning engineer (Toshiba Estia).
Certification: Manufacturer training advantageous.
On the Estia 5 Series Powerful (Hi Power / Extreme)
- Follow manufacturer's check-code flowchart.
- Rotary switch SW01 address.
Who to ask for: Installer / commissioning engineer (Toshiba Estia).
Certification: Manufacturer training advantageous.
What you might notice
Sources
- Air to Water Heat Pump Service Manual - Wall Mounted Type (File No. AE0-2101W) ↗ · AE0-2101W · page p.113 (printed page; PDF page +1) · Reviewed 23 September 2026
- Air to Water Heat Pump Service Manual (File No. A10-1704) - Estia 5 Series Indoor/Outdoor ↗ · A10-1704 · page p.88 (printed page; PDF page +1) · Reviewed 23 September 2026
- Hydro Unit Installation Manual EF99812301-4 (Powerful) ↗ · EF99812301-4 · page p.58 (printed page; PDF page +1) · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026