E03 on a Toshiba heat pump: Regular communication failure between hydro unit and remote controller
Short answer
On a Toshiba heat pump, E03 means: Regular communication failure between hydro unit and remote controller. The heat pump stops until the fault clears or is reset. An engineer is needed to fix the cause. The wording differs by model range — each is shown below.
Reviewed 23 September 2026 · 4 sources
What it means
On the R32 Estia 1-Series (split, Wall-Mounted and All-in-One)
The manual says: Regular communication failure between hydro unit and remote controller.
Part involved: remote controller and its cabling.
When it shows: No communication from remote controller for 3 min, or no controller fitted.
Likely causes:
- Remote controller connection.
- Remote controller defect.
On the Estia (Series 4) Standard & Powerful
The manual says: Regular communication error between hydro unit and remote controller.
Part involved: remote controller and its cabling.
When it shows: No communication from remote controller for 3 min.
Likely causes:
- Remote controller connection.
- Remote controller defect.
On the Estia 5 Series (Standard)
The manual says: Regular communication error between hydro unit and remote controller.
Part involved: remote controller and its cabling.
When it shows: No communication from remote controller for 3 min.
Likely causes:
- Remote controller connection.
- Remote controller defect.
On the Estia 5 Series Powerful (Hi Power / Extreme)
The manual says: Regular communication error between hydro unit and remote controller.
Part involved: remote controller and its cabling.
When it shows: Trigger thresholds not printed in the IM; see SM.
Likely causes:
- Remote controller connection.
- Remote controller defect.
Is it safe?
| Does the heat pump stop? | Yes |
|---|---|
| Severity | Fault — clears by itself when the condition goes |
| Engineer needed? | Yes |
The heat pump stops until the fault clears or is reset.
Resetting itself: yes (per manual).
Manual reset: Clear the code from the remote controller once the cause is fixed (service procedure).
What you can check
- Note the check code shown on the remote controller and the outdoor/hydro model numbers before contacting an engineer.
- Check the consumer-unit breakers/isolators for the outdoor unit, hydro unit and backup heater are switched on.
What the engineer will check
- Follow manufacturer's check-code flowchart.
- Remote controller connection.
- Remote controller defect.
Who to ask for: Heat pump engineer.
Certification: None specific.
What you might notice
Sources
- Air to Water Heat Pump Service Manual - Wall Mounted Type (File No. AE0-2101W) ↗ · AE0-2101W · page p.112 (printed page; PDF page +1) · Reviewed 23 September 2026
- Quick Reference Air to Water Heat Pump Series 4 Standard & Powerful Types ↗ · Quick Reference Series 4 Standard & Powerful (undated) · page p.61 (printed page; PDF page +1) · Reviewed 23 September 2026
- Air to Water Heat Pump Service Manual (File No. A10-1704) - Estia 5 Series Indoor/Outdoor ↗ · A10-1704 · page p.87 (printed page; PDF page +1) · Reviewed 23 September 2026
- Hydro Unit Installation Manual EF99812301-4 (Powerful) ↗ · EF99812301-4 · page p.58 (printed page; PDF page +1) · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026