Heat pumps · Error codes · Stiebel Eltron
59Stiebel Eltron · LWZ 5/8 CS Premium, LWZ 5 S Plus, LWZ 5/8 S Trend, LWZ 5 S Smart (integral ventilation units)
59 on a Stiebel Eltron LWZ 5/8 CS Premium, LWZ 5 S Plus, LWZ 5/8 S Trend, LWZ 5 S Smart: Differential pressure sensor, fan control
Short answer
On a Stiebel Eltron heat pump, 59 means: Differential pressure sensor, fan control. The heat pump keeps running with some functions stopped. An engineer is needed to fix the cause.
Reviewed 23 September 2026 · 1 source
What it means
The manual says: Differential pressure sensor, fan control.
Part involved: fans / ventilation sensors.
When it shows: Differential pressure sensor, fan control.
Likely causes:
- Differential pressure sensor in the extract air (air flow control) reading outside permissible range.
Is it safe?
| Does the heat pump stop? | Partly |
|---|---|
| Severity | Warning |
| Engineer needed? | Yes |
The heat pump keeps running with some functions stopped.
Resetting itself: no.
Manual reset: unknown.
What you can check
- Note the fault number shown on the programming unit display.
- Check the appliance breakers/MCBs at the consumer unit are on.
What the engineer will check
- Notify your qualified contractor.
Who to ask for: MVHR/ventilation-competent heat pump engineer.
What you might notice
Sources
- COMMISSIONING AND NOTIFICATION LIST LWZ 8 CS Premium / LWZ 5 CS Premium / LWZ 5 S Plus / LWZ 8 CS Trend / LWZ 8 S Trend / LWZ 5 S Trend / LWZ 5 S Smart (doc-00081766) ↗ · A 338916-45679-9862 · page 19 · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026