SolarpunkHomes
Sign inCall us · +44 7510 081687
Heat pumps
Heat pumps · Error codes · Cool Energy
Er26Cool Energy

Er26 on a Cool Energy heat pump: Heat sink temperature fault

Short answer

On a Cool Energy heat pump, Er26 means: Heat sink temperature fault. The heat pump stops until the fault clears or is reset. An engineer is needed to fix the cause. The wording differs by model range — each is shown below.

Reviewed 23 September 2026 · 2 sources

What it means

On the ecoTech DC Inverter (R32 EVI)

The manual says: Heat sink temperature fault.

On the Inverter range CE-iH (R410A, c.2020)

The manual says: PCB & Inverter PCB communication fault.

Is it safe?

Does the heat pump stop?Yes
Engineer needed?Yes

The heat pump stops until the fault clears or is reset.

What you can check

  • Read and note the code shown on the controller display, then contact your installer or service engineer.
  • Check the heat pump's breaker/isolator at the consumer unit is switched on (do not repeatedly reset if it trips).

What the engineer will check

On the ecoTech DC Inverter (R32 EVI)

  • Check compressor windings and wiring/phase sequence.
  • Check inverter drive parameters match compressor model.
  • Check operating envelope (flow, pressures, load).

Who to ask for: refrigeration / F-gas heat pump engineer.

Certification: F-gas certification; electrical competence.

On the Inverter range CE-iH (R410A, c.2020)

  • Check communication cable between controller/PCB/driver board (type, polarity, termination).
  • Check power supply to the remote module.
  • Replace faulty PCB/controller if wiring is sound.

Who to ask for: heat pump controls / electrical.

Certification: Electrical competence.

What you might notice

Sources

A code explains what the controller detected, not a confirmed root cause.

Reviewed: 23 September 2026