SolarpunkHomes
Sign inCall us · +44 7510 081687
Heat pumps
Heat pumps · Error codes · Carrier
26Carrier

26 on a Carrier heat pump: Other unit error

Short answer

On a Carrier heat pump, 26 means: Other unit error. The heat pump stops until the fault clears or is reset. An engineer is needed to fix the cause.

Reviewed 23 September 2026 · 2 sources

What it means

On the AquaSnap / AquaSnap Plus 30AWH (R410A inverter monobloc, 2010-2018 generations)

The manual says: Other unit error.

Likely causes:

  • Inverter board or compressor fault.

On the AquaSnap Plus 30AWH (R410A monobloc)

The manual says: Other unit error.

Likely causes:

  • Not stated in table.

Is it safe?

On the AquaSnap / AquaSnap Plus 30AWH (R410A inverter monobloc, 2010-2018 generations)

Does the heat pump stop?Yes
Engineer needed?Yes

The heat pump stops until the fault clears or is reset.

On the AquaSnap Plus 30AWH (R410A monobloc)

Does the heat pump stop?Yes
SeverityFault — needs a manual reset once the cause is fixed
Engineer needed?Yes

The heat pump stops until the fault clears or is reset.

What you can check

On the AquaSnap / AquaSnap Plus 30AWH (R410A inverter monobloc, 2010-2018 generations)

  • Note the code/LED pattern and the model from the rating plate, then contact a heat pump/refrigeration engineer.
  • Check the heat pump's breaker/isolator at the consumer unit is on.

On the AquaSnap Plus 30AWH (R410A monobloc)

  • Read and note the exact code shown on the controller display.
  • Check the heat pump's breaker/isolator at the consumer unit is on.
  • Restart once via the controller (OFF then ON) as the manual allows; if the code returns, call an engineer.

What the engineer will check

On the AquaSnap / AquaSnap Plus 30AWH (R410A inverter monobloc, 2010-2018 generations)

  • Read inverter board LED codes (manual §9.1/9.2) and check compressor/inverter.

Who to ask for: refrigeration / heat pump engineer.

Certification: F-gas certification (refrigerant circuit work) and electrical competence.

On the AquaSnap Plus 30AWH (R410A monobloc)

  • Not stated in table.

What you might notice

Sources

A code explains what the controller detected, not a confirmed root cause.

Reviewed: 23 September 2026