Heat pumps · Error codes · Trianco
P81Trianco · Activair R410A indoor wall hung 3kW (S300)
P81 on a Trianco Activair R410A indoor wall hung 3kW: Discharge overheating protection
Short answer
On a Trianco heat pump, P81 means: Discharge overheating protection. The manual does not say whether the heat pump stops. An engineer is needed to fix the cause.
Reviewed 23 September 2026 · 1 source
What it means
The manual says: Discharge overheating protection.
Part involved: pressure switch / compressor discharge-suction.
Is it safe?
| Does the heat pump stop? | Not stated |
|---|---|
| Engineer needed? | Yes |
The manual does not say whether the heat pump stops.
What you can check
- Note the exact code shown on the controller (a photo helps) and report it to your installer or the manufacturer's service line.
- Check the heat pump's supply breaker/isolator at the consumer unit is on (do not open any casing).
- Check the outdoor unit is not blocked by debris/snow and has its required clearances.
What the engineer will check
- Check if the refrigerant system has leak points or is blocked.
Who to ask for: refrigeration.
Certification: F-gas certified refrigeration engineer (REFCOM or equivalent).
What you might notice
Sources
- Trianco Activair Wall Hung Air Source Heat Pump S300 (R410A indoor) - Installation Operation and Service Manual ↗ · 2023-07 · page 32 · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026