SolarpunkHomes
Sign inCall us · +44 7510 081687
Heat pumps
Heat pumps · Error codes · Trianco
E051Trianco

E051 on a Trianco heat pump: Compressor Over current Shutdown Fault

Short answer

On a Trianco heat pump, E051 means: Compressor Over current Shutdown Fault. The manual does not say whether the heat pump stops. An engineer is needed to fix the cause. The wording differs by model range — each is shown below.

Reviewed 23 September 2026 · 2 sources

What it means

On the Activair High Temperature R290 (5/9/15/22kW)

The manual says: Compressor Over current Shutdown Fault.

Part involved: compressor driver / inverter board.

Likely causes:

  • Compressor over current.

On the Activair R290 Indoor (3.2kW wall hung / 5kW floor standing)

The manual says: Comp. Overcurrent Fault.

Part involved: compressor driver / inverter board.

Likely causes:

  • The compressor is overload.

Is it safe?

Does the heat pump stop?Not stated
Engineer needed?Yes

The manual does not say whether the heat pump stops.

What you can check

  • Note the exact code shown on the controller (a photo helps) and report it to your installer or the manufacturer's service line.
  • Check the heat pump's supply breaker/isolator at the consumer unit is on (do not open any casing).

What the engineer will check

On the Activair High Temperature R290 (5/9/15/22kW)

  • Check ambient temp and inlet/outlet water temp.
  • Turn on the unit.
  • record and analyse high/low pressure, discharge/suction temp, EEV step, compressor frequency and running current.
  • If they are OK, replace the compressor driver board.

Who to ask for: heat pump electrical / inverter.

Certification: Electrical competence; manufacturer-trained heat pump engineer.

On the Activair R290 Indoor (3.2kW wall hung / 5kW floor standing)

  • Check whether the system of the compressor running normally.

Who to ask for: heat pump electrical / inverter.

Certification: Electrical competence; manufacturer-trained heat pump engineer.

What you might notice

Sources

A code explains what the controller detected, not a confirmed root cause.

Reviewed: 23 September 2026