SolarpunkHomes
Sign inCall us · +44 7510 081687
Heat pumps
Heat pumps · Error codes · Samsung
E653Samsung

E653 on a Samsung heat pump: AI Home temp sensor SHORT or OPEN

Short answer

On a Samsung heat pump, E653 means: AI Home temp sensor SHORT or OPEN. The heat pump stops until the fault clears or is reset. An engineer is needed to fix the cause. The wording differs by model range — each is shown below.

Reviewed 23 September 2026 · 2 sources

What it means

On the EHS Mono R290 (AE***CXYD*K and pump-integrated AE***CXYB*K)

The manual says: AI Home temp sensor SHORT or OPEN.

Part involved: Wired remote controller / AI Home controller.

When it shows: Unit self-diagnosis: AI Home temp sensor SHORT or OPEN.

Likely causes:

  • Wired remote controller communication, setting, sensor or memory fault; controller wiring (F3/F4) fault.
  • Engineer checks per Samsung service manual: Follow Samsung service manual troubleshooting for this code.

On the EHS Mono R32 (AE***RXYD*G)

The manual says: Wired remote controller temp sensor SHORT or OPEN.

Part involved: Wired remote controller / AI Home controller.

When it shows: Unit self-diagnosis: Wired remote controller temp sensor SHORT or OPEN.

Likely causes:

  • Wired remote controller communication, setting, sensor or memory fault; controller wiring (F3/F4) fault.
  • Engineer checks per Samsung service manual: Follow Samsung service manual troubleshooting for this code.

Is it safe?

Does the heat pump stop?Yes
Engineer needed?Yes

The heat pump stops until the fault clears or is reset.

Resetting itself: unknown.

Manual reset: unknown.

What you can check

  • Note the full error code shown on the controller; check the heat pump breaker/isolator in the consumer unit is ON; check thermostat/timer and controller operating-mode settings; then contact your installer or Samsung service; Samsung manuals do not describe a homeowner reset for this code.

What the engineer will check

  • Follow Samsung service manual troubleshooting for this code. Any work inside casings, on PCBs, wiring, sensors, pumps, valves or refrigerant is engineer-only.

Who to ask for: Heat pump engineer (controls).

Certification: Competent electrical worker (BS 7671).

What you might notice

What owners and engineers report

9 owner and engineer reports mention this.

  • Controller / thermostat problem on the EHS Mono R290 (AE***CXYD*K and pump-integrated AE***CXYB*K): 2 reports
  • Controller / thermostat problem on the EHS Mono R32 (AE***RXYD*G): 7 reports

Sources

A code explains what the controller detected, not a confirmed root cause.

Reviewed: 23 September 2026