SolarpunkHomes
Sign inCall us · +44 7510 081687
Heat pumps
Heat pumps · Error codes · Samsung
E322Samsung · EHS Mono HT Quiet (AE***BXYD*G)

E322 on a Samsung EHS Mono HT Quiet: EVI Outlet Sensor Error (open/short)

Short answer

On a Samsung heat pump, E322 means: EVI Outlet Sensor Error (open/short). The heat pump stops until the fault clears or is reset. An engineer is needed to fix the cause.

Reviewed 23 September 2026 · 1 source

What it means

The manual says: EVI Outlet Sensor Error (open/short).

Part involved: EVI Outlet Sensor Error (open/short).

When it shows: Unit self-diagnosis: EVI Outlet Sensor Error (open/short).

Likely causes:

  • Refrigerant-side temperature sensor open/short circuit, detached or mis-located; connector or PCB fault.
  • Engineer checks per Samsung service manual: Check sensor connection status, sensor location and sensor resistance against the Samsung resistance table (103 or 204 type); replace sensor or PCB if required.

Is it safe?

Does the heat pump stop?Yes
Engineer needed?Yes

The heat pump stops until the fault clears or is reset.

Resetting itself: unknown.

Manual reset: unknown.

What you can check

  • Note the full error code shown on the controller; check the heat pump breaker/isolator in the consumer unit is ON; then contact your installer or Samsung service; Samsung manuals do not describe a homeowner reset for this code.

What the engineer will check

  • Check sensor connection status, sensor location and sensor resistance against the Samsung resistance table (103 or 204 type); replace sensor or PCB if required. Any work inside casings, on PCBs, wiring, sensors, pumps, valves or refrigerant is engineer-only.

Who to ask for: Heat pump engineer (Samsung-trained).

Certification: Competent electrical worker (BS 7671).

What you might notice

What owners and engineers report

2 owner and engineer reports mention this.

  • Keeps stopping / cutting out on the EHS Mono HT Quiet (AE***BXYD*G): 1 report
  • No heating on the EHS Mono HT Quiet (AE***BXYD*G): 1 report

Sources

A code explains what the controller detected, not a confirmed root cause.

Reviewed: 23 September 2026