Heat pumps · Error codes · Samsung
E163Samsung · Samsung, all models
E163 on a Samsung heat pump: EEPROM OPTION SETTING Error
Short answer
On a Samsung heat pump, E163 means: EEPROM OPTION SETTING Error. The heat pump stops until the fault clears or is reset. An engineer is needed to fix the cause.
Reviewed 23 September 2026 · 1 source
What it means
The manual says: EEPROM OPTION SETTING Error.
Part involved: PCB EEPROM / data memory.
When it shows: Unit self-diagnosis: EEPROM OPTION SETTING Error.
Likely causes:
- PCB memory (EEPROM/data flash) or option-setting data fault.
- Engineer checks per Samsung service manual: Check EEPROM option settings; re-enter options or replace EEPROM/PCB.
Is it safe?
| Does the heat pump stop? | Yes |
|---|---|
| Engineer needed? | Yes |
The heat pump stops until the fault clears or is reset.
Resetting itself: unknown.
Manual reset: unknown.
What you can check
- Note the full error code shown on the controller; check the heat pump breaker/isolator in the consumer unit is ON; then contact your installer or Samsung service; Samsung manuals do not describe a homeowner reset for this code.
What the engineer will check
- Check EEPROM option settings; re-enter options or replace EEPROM/PCB. Any work inside casings, on PCBs, wiring, sensors, pumps, valves or refrigerant is engineer-only.
Who to ask for: Heat pump engineer (Samsung-trained, PCB diagnostics).
Certification: Competent electrical worker (BS 7671).
What you might notice
Sources
- EHS R290 Mono Outdoor Unit Installation Manual AE***CXYD** (EU) DB68-12496A-03 ↗ · DB68-12496A-03 · page p.24 · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026