Heat pumps · Error codes · Ideal Heating
506Ideal Heating · Logic Air
506 on an Ideal Heating Logic Air: Boiler no temp' rise Fault
Short answer
On an Ideal Heating heat pump, 506 means: Boiler no temp' rise Fault. The manual does not say whether the heat pump stops. An engineer is needed to fix the cause.
Reviewed 23 September 2026 · 1 source
What it means
The manual says: Boiler no temp' rise Fault.
Part involved: back-up boiler.
Likely causes:
- Back-up boiler is in a fault condition (no temperature rise detected).
Is it safe?
| Does the heat pump stop? | Not stated |
|---|---|
| Engineer needed? | Yes |
The manual does not say whether the heat pump stops.
What you can check
- Note the code or fault message shown on the controller/Halo and when it appeared; check the heat pump's isolator and consumer-unit breaker are on.
What the engineer will check
- Check the back-up boiler for its own fault condition.
Who to ask for: Gas Safe registered engineer (boiler).
Certification: Gas Safe registration for boiler work.
Sources
- Logic Air Monobloc Heat Pump System - Installation & Maintenance (UIN 241428 A03) ↗ · UIN 241428 A03 · page 84 · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026