Heat pumps · Error codes · Ideal Heating
100Ideal Heating · Logic Air
100 on an Ideal Heating Logic Air: 2 clock time masters Fault
Short answer
On an Ideal Heating heat pump, 100 means: 2 clock time masters Fault. The manual does not say whether the heat pump stops. An engineer is needed to fix the cause.
Reviewed 23 September 2026 · 1 source
What it means
The manual says: 2 clock time masters Fault.
Part involved: controller clock/bus.
Likely causes:
- Two devices on the bus configured as clock time master.
Is it safe?
| Does the heat pump stop? | Not stated |
|---|---|
| Engineer needed? | Yes |
The manual does not say whether the heat pump stops.
What you can check
- Note the code or fault message shown on the controller/Halo and when it appeared; check the heat pump's isolator and consumer-unit breaker are on.
What the engineer will check
- Reconfigure so only one device is clock master (flowchart text on p.80 is poorly laid out in PDF text layer).
Who to ask for: Heat pump / heating controls engineer.
Sources
- Logic Air Monobloc Heat Pump System - Installation & Maintenance (UIN 241428 A03) ↗ · UIN 241428 A03 · page 80 · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026