Heat pumps · Error codes · Haier
14Haier · Super Aqua Split (R32, AW..SSCHA/SNCHA + HU..WAMNA)
14 on a Haier Super Aqua Split: low pressure abnormal
Short answer
On a Haier heat pump, 14 means: low pressure abnormal. The heat pump stops until the fault clears or is reset. An engineer is needed to fix the cause.
Reviewed 23 September 2026 · 1 source
What it means
The manual says: low pressure abnormal.
Part involved: compressor, pressure switch/sensor, expansion valve, refrigerant charge.
Is it safe?
| Does the heat pump stop? | Yes |
|---|---|
| Severity | Fault — clears by itself when the condition goes |
| Engineer needed? | Yes |
The heat pump stops until the fault clears or is reset.
Resetting itself: yes.
What you can check
- Note the code shown on the controller and the unit model numbers (on the rating plate label) before contacting your installer.
- Check the heat pump's breaker/isolator at the consumer unit is on; do not open any casing.
- Check the outdoor unit is not blocked by leaves, debris, snow or ice and that nothing is stored against the grilles.
What the engineer will check
- Follow the manufacturer's troubleshooting flowchart for this code.
- Check refrigerant pressures and charge (F-gas / flammable refrigerant competent person only).
- Check expansion valve, pressure switches/sensors and discharge temperature.
- Check outdoor coil airflow and blockages.
Who to ask for: Heat pump engineer.
Certification: Heat pump installer competence; F-gas / flammable-refrigerant (R290/R32) handling competence for any refrigerant-circuit work.
What you might notice
Sources
- Operation & Installation Manual - Air-to-Water Heat Pump Indoor Unit HU062WAMNA / HU102WAMNA (No. 0150554179) ↗ · 0150554179 · page p.17 (printed; PDF p.19) · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026