Heat pumps · Error codes · Danfoss
low-evap-temp-2Danfoss · DHP-AQ
low-evap-temp-2 on a Danfoss DHP-AQ: Too great a deviation in evaporation temperature average value
Short answer
On a Danfoss heat pump, low-evap-temp-2 means: Too great a deviation in evaporation temperature average value. The heat pump stops until the fault clears or is reset. An engineer is needed to fix the cause.
Reviewed 23 September 2026 · 1 source
What it means
The manual says: Too great a deviation in evaporation temperature average value.
Part involved: evaporation temperature.
Likely causes:
- Unstable evaporation temperature - not tabulated.
Is it safe?
| Does the heat pump stop? | Yes |
|---|---|
| Engineer needed? | Yes |
The heat pump stops until the fault clears or is reset.
Manual reset: Set operating mode OFF then back to the desired mode.
What you can check
- Note the exact alarm text. Check the outdoor unit is not blocked by snow, ice, leaves or debris and that airflow around it is clear. The manual allows acknowledging by setting operating mode OFF then back once; if the alarm returns, call an engineer.
What the engineer will check
- Check EXV operation, sensors, charge.
Who to ask for: heat pump engineer.
Certification: F-Gas category I certificate (refrigerant circuit work).
What you might notice
Sources
- Service Instructions DHP-AQ (VMGFJ202) ↗ · VMGFJ202 · page p.10 · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026