com-error-hp-card on a Danfoss DHP-AQ: Communication broken between display card and heat pump card (outdoor)
Short answer
On a Danfoss heat pump, com-error-hp-card means: Communication broken between display card and heat pump card (outdoor). The heat pump stops until the fault clears or is reset. An engineer is needed to fix the cause.
Reviewed 23 September 2026 · 1 source
What it means
The manual says: Communication broken between display card and heat pump card (outdoor).
Part involved: display card - outdoor heat pump card link.
Likely causes:
- Communication cable/connection fault or card fault (see troubleshooting guide VMIFB202 p.16).
Is it safe?
| Does the heat pump stop? | Yes |
|---|---|
| Engineer needed? | Yes |
The heat pump stops until the fault clears or is reset.
Manual reset: Set operating mode OFF then back to the desired mode.
What you can check
- Note the exact alarm text. Check the heat pump's breaker/isolator at the consumer unit is on and has not tripped. The manual allows acknowledging by setting operating mode OFF then back once; if the alarm returns, call an engineer.
What the engineer will check
- Check communication cable between indoor and outdoor unit; swap TP cable; test with replacement card.
Who to ask for: heat pump engineer.
Certification: Qualified electrician / heat pump engineer (electrical fault-finding).
What you might notice
Sources
- Service Instructions DHP-AQ (VMGFJ202) ↗ · VMGFJ202 · page p.10 · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026