Heat pumps · Error codes · Ariston
935Ariston · NIMBUS NET R32 control platform (shared error list)
935 on an Ariston NIMBUS NET R32 control platform: Tank overtemperature
Short answer
On an Ariston heat pump, 935 means: Tank overtemperature. The heat pump keeps running with some functions stopped. An engineer is needed to fix the cause.
Reviewed 23 September 2026 · 1 source
What it means
The manual says: Tank overtemperature.
Part involved: DHW tank / diverter valve.
Likely causes:
- 3-way valve locked in the DHW position.
- Tank sensor connection/defect.
Is it safe?
| Does the heat pump stop? | Partly |
|---|---|
| Engineer needed? | Yes |
The heat pump keeps running with some functions stopped.
What you can check
- Note the error code shown on the Sensys HD interface and contact the installer / Ariston service.
What the engineer will check
- Check whether the 3-way valve is locked in the DHW position.
- Check tank sensor connection and replace if necessary.
Who to ask for: heat pump controls / hydronics.
Certification: Competent heating engineer; electrical competence for wiring checks.
What you might notice
Sources
- NIMBUS PLUS M NET R32 - Technical instructions for installation and maintenance (UK) - codes 3301719 3301720, doc 420000656201 EN ↗ · 420011311701 - 03/2024 · page 71 · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026