Heat pumps · Error codes · Ariston
2P9Ariston · NIMBUS NET R32 control platform (shared error list)
2P9 on an Ariston NIMBUS NET R32 control platform: SG ready input configuration error
Short answer
On an Ariston heat pump, 2P9 means: SG ready input configuration error. The manual does not say whether the heat pump stops. An engineer is needed to fix the cause.
Reviewed 23 September 2026 · 1 source
What it means
The manual says: SG ready input configuration error.
Part involved: SG Ready inputs.
Likely causes:
- Only one of parameters 1.1.0 or 1.1.1 is set as an SG Ready input.
Is it safe?
| Does the heat pump stop? | Not stated |
|---|---|
| Severity | Warning |
| Engineer needed? | Yes |
The manual does not say whether the heat pump stops.
What you can check
- Note the error code shown on the Sensys HD interface and contact the installer / Ariston service - this is a configuration error set at commissioning.
What the engineer will check
- Correct SG Ready input configuration (parameters 1.1.0 / 1.1.1).
Who to ask for: heat pump controls / hydronics.
Certification: Competent heating engineer; electrical competence for wiring checks.
What you might notice
Sources
- NIMBUS PLUS M NET R32 - Technical instructions for installation and maintenance (UK) - codes 3301719 3301720, doc 420000656201 EN ↗ · 420011311701 - 03/2024 · page 71 · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026