E2X.T10 on a Worcester Bosch Greenstore LECP ground source heat pump: Low temperature collector circuit in
Short answer
On a Worcester Bosch heat pump, E2X.T10 means: Low temperature collector circuit in. The heat pump keeps running with some functions stopped. An engineer is needed to fix the cause.
Reviewed 23 September 2026 · 1 source
What it means
The manual says: Low temperature collector circuit in.
Part involved: T10 collector in.
When it shows: T10 too low; warning becomes category A alarm if repeated.
Likely causes:
- T10 too low; warning becomes category A alarm if repeated.
Is it safe?
| Does the heat pump stop? | Partly |
|---|---|
| Severity | Fault — needs a manual reset once the cause is fixed |
| Engineer needed? | Yes |
The heat pump keeps running with some functions stopped.
Resetting itself: no.
Manual reset: Acknowledgement required in category A.
What you can check
- Read and note the full alarm text and category letter shown on the controller and pass it to your installer.
- Acknowledge the alarm on the control unit once (the manual allows acknowledgement); if it recurs call the installer.
What the engineer will check
- Diagnose per chapter 21: T10 too low; warning becomes category A alarm if repeated.
Who to ask for: ground source heat pump engineer.
Certification: F-gas certification for refrigerant circuit; competent person for electrical work.
What you might notice
Sources
- Installation, Commissioning and Servicing Instructions Worcester Greenstore LECP GSHP (System/Combi 6-11 kW) ↗ · 6 720 806 768 (2013/02) · page 59-60 · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026