SolarpunkHomes
Sign inCall us · +44 7510 081687
Heat pumps
Heat pumps · Error codes · Stiebel Eltron
CENTRAL-FAULTStiebel Eltron · WPM 3 heat pump manager (older controller)

CENTRAL-FAULT on a Stiebel Eltron WPM 3 heat pump manager: 230 V signal not present at the IWS fault inputs 10 s after a controlled heat pump shutdown; red LED on IWS flashes

Short answer

On a Stiebel Eltron heat pump, CENTRAL-FAULT means: 230 V signal not present at the IWS fault inputs 10 s after a controlled heat pump shutdown; red LED on IWS flashes. The heat pump stops until the fault clears or is reset. An engineer is needed to fix the cause.

Reviewed 23 September 2026 · 1 source

What it means

The manual says: 230 V signal not present at the IWS fault inputs 10 s after a controlled heat pump shutdown; red LED on IWS flashes.

Part involved: water flow / pump / booster heater.

When it shows: 230 V signal not present at the IWS fault inputs 10 s after a controlled heat pump shutdown; red LED on IWS flashes.

Likely causes:

  • Fault input chain on IWS interrupted (e.g. safety device/protective contact open).

Is it safe?

Does the heat pump stop?Yes
SeverityFault — clears by itself when the condition goes
Engineer needed?Yes

The heat pump stops until the fault clears or is reset.

Resetting itself: yes - restarts after IWS fault time/idle time.

Manual reset: after 5 faults in 2 h run: IWS reset.

What you can check

  • Read and note the full message code and time from the WPM display (DIAGNOSIS / NOTIFICATIONLIST if accessible without a code).
  • Check the heat pump and controller circuit breakers/isolators at the consumer unit are on.
  • Check the heating system pressure gauge reading is in the normal range stated by your installer.
  • Check the outdoor unit air intake/discharge is not blocked by leaves, snow or ice (air source units).

What the engineer will check

  • Fault input chain on IWS interrupted (e.g. safety device/protective contact open).

Who to ask for: Heating / heat pump engineer.

What you might notice

Sources

A code explains what the controller detected, not a confirmed root cause.

Reviewed: 23 September 2026