8167 on a Stiebel Eltron WPM 3 heat pump manager: The heat pump type set with the rotary selector does not match the installed electronic assembly
Short answer
On a Stiebel Eltron heat pump, 8167 means: The heat pump type set with the rotary selector does not match the installed electronic assembly. The heat pump stops until the fault clears or is reset. An engineer is needed to fix the cause.
Reviewed 23 September 2026 · 1 source
What it means
The manual says: The heat pump type set with the rotary selector does not match the installed electronic assembly.
Part involved: water flow / pump / booster heater.
When it shows: The heat pump type set with the rotary selector does not match the installed electronic assembly.
Likely causes:
- Set the rotary selector to the correct position or replace the electronic assembly.
Is it safe?
| Does the heat pump stop? | Yes |
|---|---|
| Severity | Fault — clears by itself when the condition goes |
| Engineer needed? | Yes |
The heat pump stops until the fault clears or is reset.
Resetting itself: yes - restarts after IWS fault time/idle time.
Manual reset: after 5 faults in 2 h run: IWS reset.
What you can check
- Read and note the full message code and time from the WPM display (DIAGNOSIS / NOTIFICATIONLIST if accessible without a code).
- Check the heat pump and controller circuit breakers/isolators at the consumer unit are on.
- Check the heating system pressure gauge reading is in the normal range stated by your installer.
- Check the outdoor unit air intake/discharge is not blocked by leaves, snow or ice (air source units).
What the engineer will check
- Set the rotary selector to the correct position or replace the electronic assembly.
Who to ask for: Heating / heat pump engineer.
What you might notice
Sources
- OPERATION AND INSTALLATION Heat pump manager WPM 3 (DM0000035521) ↗ · A 316199-43934-9674 · page 52 · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026