SolarpunkHomes
Sign inCall us · +44 7510 081687
Heat pumps
Heat pumps · Error codes · Stiebel Eltron
20093Stiebel Eltron · WPM heat pump manager / WPMsystem (controller platform)

20093 on a Stiebel Eltron WPM heat pump manager / WPMsystem: Low relevance communication objects have been incorrectly transferred repeatedly between the IWS and inverter

Short answer

On a Stiebel Eltron heat pump, 20093 means: Low relevance communication objects have been incorrectly transferred repeatedly between the IWS and inverter. The heat pump stops until the fault clears or is reset. An engineer is needed to fix the cause.

Reviewed 23 September 2026 · 1 source

What it means

The manual says: Low relevance communication objects have been incorrectly transferred repeatedly between the IWS and inverter.

Part involved: compressor or fan inverter.

When it shows: Low relevance communication objects have been incorrectly transferred repeatedly between the IWS and inverter.

Likely causes:

  • Inverter fault. Check leads and the relevant plug-in connectors, and replace if faulty. Check the power supply to the inverter.

Is it safe?

Does the heat pump stop?Yes
SeverityFault — clears by itself when the condition goes
Engineer needed?Yes

The heat pump stops until the fault clears or is reset.

Resetting itself: yes - heat pump restarts after idle time (~10-12 min); locks out after 5 faults in 2 h run.

Manual reset: after 5 faults in 2 h: IWS/WPM reset.

What you can check

  • Read and note the full message code and time from the WPM display (DIAGNOSIS / NOTIFICATIONLIST if accessible without a code).
  • Check the heat pump and controller circuit breakers/isolators at the consumer unit are on.

What the engineer will check

  • Inverter fault. Check leads and the relevant plug-in connectors, and replace if faulty. Check the power supply to the inverter.

Who to ask for: Heat pump service engineer (electrical/controls).

Certification: Qualified electrician competence for live-work on appliance electrics.

What you might notice

Sources

A code explains what the controller detected, not a confirmed root cause.

Reviewed: 23 September 2026