20050 on a Stiebel Eltron WPM heat pump manager / WPMsystem: Temperature limiter for minimum heat source flow temperature has tripped
Short answer
On a Stiebel Eltron heat pump, 20050 means: Temperature limiter for minimum heat source flow temperature has tripped. The heat pump stops until the fault clears or is reset. An engineer is needed to fix the cause.
Reviewed 23 September 2026 · 1 source
What it means
The manual says: Temperature limiter for minimum heat source flow temperature has tripped.
Part involved: brine circuit.
When it shows: Temperature limiter for minimum heat source flow temperature has tripped.
Likely causes:
- Check brine circuit.
Is it safe?
| Does the heat pump stop? | Yes |
|---|---|
| Severity | Fault — clears by itself when the condition goes |
| Engineer needed? | Yes |
The heat pump stops until the fault clears or is reset.
Resetting itself: yes - heat pump restarts after idle time (~10-12 min); locks out after 5 faults in 2 h run.
Manual reset: after 5 faults in 2 h: IWS/WPM reset.
What you can check
- Read and note the full message code and time from the WPM display (DIAGNOSIS / NOTIFICATIONLIST if accessible without a code).
- Check the heat pump and controller circuit breakers/isolators at the consumer unit are on.
What the engineer will check
- Check brine circuit.
Who to ask for: Ground source heat pump engineer.
What you might notice
Sources
- WPM notification list (WPM V2.9) - multilingual; English section pp.15-26 (DOC-00081866) ↗ · WPM V2.9 · page 16 · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026