E881 on a Rinnai heat pump: Supply voltage out of limits (DC Bus Error)
Short answer
On a Rinnai heat pump, E881 means: Supply voltage out of limits (DC Bus Error). The heat pump stops until the fault clears or is reset. An engineer is needed to fix the cause. The wording differs by model range — each is shown below.
Reviewed 24 September 2026 · 2 sources
What it means
On the HPI (HPi32) R32 monobloc
The manual says: Supply voltage out of limits (DC Bus Error).
Part involved: compressor inverter drive board.
On the R290 monobloc (HPR290)
The manual says: Supply voltage out of limits.
Part involved: compressor inverter drive board.
Is it safe?
| Does the heat pump stop? | Yes |
|---|---|
| Engineer needed? | Yes |
The heat pump stops until the fault clears or is reset.
Resetting itself: unknown.
What you can check
- Note the code shown on the controller and the model number on the unit's rating label before contacting your installer.
- Check that the heat pump's isolator and consumer-unit breaker are on; do not open any casing.
What the engineer will check
- Check supply voltage and phase at the unit terminals.
- Check compressor U/V/W connections and compressor winding resistance.
- Check drive board heatsink cooling and fan.
- Replace the inverter/driver board if faults persist.
Who to ask for: Heat pump engineer.
Certification: Heat pump installer competence; F-gas and flammable-refrigerant (R32/R290) handling competence for any refrigerant-circuit work.
What you might notice
Sources
- Maxa i-32V5 Heat pump air/water inverters with axial fans - Controller Manual ↗ · page p.36 (MAXA i-32V5 controller manual) · Reviewed 24 September 2026
- Maxa i-290 Inverter air/water heat pumps with axial fans - Controller Manual (0106-0118) ↗ · page p.44 (MAXA i-290 controller manual) · Reviewed 24 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 24 September 2026