Heat pumps · Error codes · Mitsubishi Heavy Industries Air-Conditioning Europe
226Mitsubishi Heavy Industries Air-Conditioning Europe · Hydrolution (split, FDCW outdoor units)
226 on a Mitsubishi Heavy Industries Air-Conditioning Europe Hydrolution: Stove monitor activated: Stove monitor activated
Short answer
On a Mitsubishi Heavy Industries Air-Conditioning Europe heat pump, 226 means: Stove monitor activated: Stove monitor activated. The heat pump keeps running.
Reviewed 23 September 2026 · 1 source
What it means
The manual says: Stove monitor activated: Stove monitor activated.
Part involved: Stove monitor activated.
When it shows: Stove monitor activated.
Likely causes:
- -.
Is it safe?
| Does the heat pump stop? | No |
|---|---|
| Severity | Information only |
| Engineer needed? | No |
The heat pump keeps running.
Resetting itself: yes.
Manual reset: no.
What you can check
- Note the alarm number/text shown on the display. Check the consumer-unit breakers/isolators for the indoor and outdoor units are on. Check the outdoor unit is not blocked by leaves, snow or ice and its drain is clear (look only - do not open the casing). This is an information message; it resets automatically when the cause is removed.
What the engineer will check
- Per manual 'May be due to': -. Check sensor wiring/resistance, settings, flow (particle filter, pump) and supply as applicable.
Who to ask for: Heat pump / refrigeration engineer (manufacturer-trained).
Certification: F-gas certification for refrigerant-circuit work; electrical competence (Part P/18th Edition) for PCB/wiring.
What you might notice
Sources
- Installation Manual - Air to Water Heat Pump using R32 refrigerant, Hydrolution (HM) ↗ · PSC012D169 (202201) · page PDF p.88 (printed 86) · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026