A* on a Mitsubishi Electric Ecodan: M-NET communication error (A* codes)
Short answer
On a Mitsubishi Electric heat pump, A* means: M-NET communication error (A* codes). The heat pump stops until the fault clears or is reset. An engineer is needed to fix the cause.
Reviewed 23 September 2026 · 1 source
What it means
The manual says: M-NET communication error (A* codes).
Part involved: M-NET communication (multiple/commercial outdoor units).
When it shows: Any A-prefixed code.
Likely causes:
- M-NET communication fault.
Is it safe?
| Does the heat pump stop? | Yes |
|---|---|
| Severity | Fault — needs a manual reset once the cause is fixed |
| Engineer needed? | Yes |
The heat pump stops until the fault clears or is reset.
Resetting itself: Not stated as auto-resetting; code remains until reset.
Manual reset: Installation manuals: press F4 (RESET) then F3 (Yes) on the main remote controller (older controllers: hold button E for 3 s); 'To cancel error codes please switch system off'. Fix the cause first.
What you can check
- Note the code, unit and ref. address shown on the main remote controller and contact your installer (Mitsubishi user manuals: 'Make a note of the error code number and contact installer'). Check the heat pump breaker/isolator at the consumer unit is on and read the primary system pressure gauge (if fitted) so you can report it. A single reset from the main remote controller (RESET, then Yes) may be tried; if the code returns, do not keep resetting. Do not open the outdoor unit, cylinder/hydrobox or any casing. A power cycle is a Mitsubishi first step for communication codes: switching the heat pump off and on at its isolator (outdoor and indoor supplies) once is acceptable.
What the engineer will check
- Refer to outdoor unit service manual.
Who to ask for: Mitsubishi Ecodan-trained heat pump engineer (controls / wiring).
Sources
- Ecodan FTC7 PAC-IF08(1-3)B-E Installation Manual (DG79H200H01) ↗ · DG79H200H01 · page 32 (PDF p.33, 6.2 Self-check) · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026