Heat pumps · Error codes · Kingspan
6Kingspan · Aeromax Plus air-to-water monobloc (KHP0038-KHP0042)
6 on a Kingspan Aeromax Plus air-to-water monobloc: Loss of communication to NUI control
Short answer
On a Kingspan heat pump, 6 means: Loss of communication to NUI control. The heat pump keeps running with some functions stopped. An engineer is needed to fix the cause.
Reviewed 23 September 2026 · 1 source
What it means
The manual says: Loss of communication to NUI control.
Part involved: KHP0008 controller / NUI communication.
Likely causes:
- Controller disconnected or cable fault.
Is it safe?
| Does the heat pump stop? | Partly |
|---|---|
| Severity | Fault — clears by itself when the condition goes |
| Engineer needed? | Yes |
The heat pump keeps running with some functions stopped.
Resetting itself: Manual: after the error has been cleared, reset by turning off the mains supply for 10 seconds and on again.
What you can check
- Note the code/LED pattern and the model from the rating plate, then contact a heat pump/refrigeration engineer.
- Check the heat pump's breaker/isolator at the consumer unit is on.
What the engineer will check
- Check controller cable and connections between NUI and GMC board.
Who to ask for: refrigeration / heat pump engineer.
Certification: Electrical competence for work inside the unit.
What you might notice
Sources
- Kingspan Aeromax Plus Air Source Heat Pump Installation and Maintenance Manual (KHP0041/38/39/40/42), A9317C Ver 1.2b ↗ · A9317C Ver 1.2b · page 24 · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026