Heat pumps · Error codes · Kensa
E5Kensa
E5 on a Kensa heat pump: T5 temperature probe error (ground return)
Short answer
On a Kensa heat pump, E5 means: T5 temperature probe error (ground return). The heat pump stops until the fault clears or is reset. An engineer is needed to fix the cause.
Reviewed 23 September 2026 · 4 sources
What it means
The manual says: T5 temperature probe error (ground return).
Part involved: T5 ground return probe.
When it shows: Error level per manual: Fault.
Likely causes:
- T5 probe faulty or disconnected.
Is it safe?
| Does the heat pump stop? | Yes |
|---|---|
| Engineer needed? | Yes |
The heat pump stops until the fault clears or is reset.
Resetting itself: unknown.
Manual reset: unknown.
What you can check
- Note the code shown on the controller/LED; check the heat pump isolator and consumer-unit breaker are on; check thermostat/timer settings.
What the engineer will check
- Follow Kensa fault table actions: T5 probe faulty or disconnected.
Who to ask for: Heat pump controls engineer / Kensa technical support.
Certification: MCS-certified GSHP installer recommended; Kensa-trained.
What you might notice
Sources
- Kensa Evo Heat Pump Installation manual ↗ · V32 · page 52 · Reviewed 23 September 2026
- Q80 Series Heat Pump Operational Manual ↗ · Version 2 · page 25 · Reviewed 23 September 2026
- Shoebox Heat Pump Operational Manual (User Manual) ↗ · Version 8 · page 28 · Reviewed 23 September 2026
- Kensa Shoebox NX heat pump Installation manual ↗ · V12 · page 42 · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026