DHT2 on a Kensa heat pump: Discharge gas temperature T8 exceeds factory high limit (twin only)
Short answer
On a Kensa heat pump, DHT2 means: Discharge gas temperature T8 exceeds factory high limit (twin only). The heat pump keeps running with some functions stopped. An engineer is needed to fix the cause.
Reviewed 23 September 2026 · 2 sources
What it means
The manual says: Discharge gas temperature T8 exceeds factory high limit (twin only).
Part involved: T8 discharge / compressor 2.
When it shows: Error level per manual: Fault or Warning.
Likely causes:
- Compressor overheating (often with HP2); evaporating temperature too high.
Is it safe?
| Does the heat pump stop? | Partly |
|---|---|
| Engineer needed? | Yes |
The heat pump keeps running with some functions stopped.
Resetting itself: unknown.
Manual reset: unknown.
What you can check
- Note the code shown on the controller/LED; check the heat pump isolator and consumer-unit breaker are on; check thermostat/timer settings.
What the engineer will check
- Follow Kensa fault table actions: Compressor overheating (often with HP2); evaporating temperature too high.
Who to ask for: Refrigeration engineer (F-gas certified) / Kensa technical support.
Certification: F-gas Category I (refrigerant circuit work); MCS-certified GSHP installer.
What you might notice
Sources
- Q80 Series Heat Pump Operational Manual ↗ · Version 2 · page 24 · Reviewed 23 September 2026
- Shoebox Heat Pump Operational Manual (User Manual) ↗ · Version 8 · page 27 · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026