Heat pumps · Error codes · Immergas
EEImmergas · MAGIS M monobloc R32 (M4-M30 T) - sold in UK as Alpha Magis M
EE on an Immergas MAGIS M monobloc R32 - sold in UK as Alpha Magis M: EEPROM fault of the hydraulic module main control board
Short answer
On an Immergas heat pump, EE means: EEPROM fault of the hydraulic module main control board. The manual does not say whether the heat pump stops. An engineer is needed to fix the cause.
Reviewed 23 September 2026 · 1 source
What it means
The manual says: EEPROM fault of the hydraulic module main control board.
Likely causes:
- EEPROM data error.
- EEPROM component damaged.
- Main board damaged.
Is it safe?
| Does the heat pump stop? | Not stated |
|---|---|
| Engineer needed? | Yes |
The manual does not say whether the heat pump stops.
Manual reset: Manual 13.4: reset the safety device by switching the unit off and back on; if this fails contact your local dealer.
What you can check
- Note the code on the control panel and contact the installer / Alpha-Immergas authorised service.
- The manual says to reset the safety device by switching the unit off and back on; if the reset fails, contact the dealer - do not keep resetting.
What the engineer will check
- EEPROM data error.
- EEPROM component damaged.
- Main board damaged.
Who to ask for: heat pump engineer.
Certification: Electrical competence.
What you might notice
Sources
- MAGIS M4-30 Block heat pumps - Use and Installation - Instructions and warnings (IE edition), *1.046978ENG* ↗ · 1.046978ENG · page 126 · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026