SolarpunkHomes
Sign inCall us · +44 7510 081687
Heat pumps
Heat pumps · Error codes · Hisense
07Hisense · Hi-Therma Monobloc (R32)

07 on a Hisense Hi-Therma Monobloc: Decrease in Discharge Gas Superheat

Short answer

On a Hisense heat pump, 07 means: Decrease in Discharge Gas Superheat. The heat pump stops until the fault clears or is reset. An engineer is needed to fix the cause.

Reviewed 23 September 2026 · 1 source

What it means

The manual says: Decrease in Discharge Gas Superheat.

Part involved: high-pressure switch PSH, expansion valve, refrigerant charge, compressor.

Likely causes:

  • Excessive Refrigerant Charge.
  • Failure of Thermistor.
  • Incorrect Wiring.
  • Incorrect Piping Connection.
  • Expansion Valve Locking at Opened Position (Disconnect Connector).

Is it safe?

Does the heat pump stop?Yes
SeverityFault — clears by itself when the condition goes
Engineer needed?Yes

The heat pump stops until the fault clears or is reset.

Resetting itself: unknown.

What you can check

  • Note the code shown on the controller and the unit model numbers (on the rating plate label) before contacting your installer.
  • Check the heat pump's breaker/isolator at the consumer unit is on; do not open any casing.
  • Check the outdoor unit is not blocked by leaves, debris, snow or ice and that nothing is stored against the grilles.

What the engineer will check

  • Follow the handbook alarm-code flowchart (O.U. section from printed p.335, I.U. section from viewer p.383).
  • Check sensor connector and wiring.
  • Measure sensor resistance against the manual's sensor table.
  • Replace sensor or PCB as indicated by the troubleshooting flowchart.

Who to ask for: Heat pump engineer.

Certification: Heat pump installer competence; F-gas / flammable-refrigerant (R290/R32) handling competence for any refrigerant-circuit work.

What you might notice

Sources

A code explains what the controller detected, not a confirmed root cause.

Reviewed: 23 September 2026