Heat pumps · Error codes · Haier
L6Haier · HPM-Nd2 monobloc (R290, Haier Water Heater Co.)
L6 on a Haier HPM-Nd2 monobloc: Fan 2 feedback failure
Short answer
On a Haier heat pump, L6 means: Fan 2 feedback failure. The heat pump stops until the fault clears or is reset. An engineer is needed to fix the cause.
Reviewed 23 September 2026 · 1 source
What it means
The manual says: Fan 2 feedback failure.
Part involved: DC fan motor and drive.
Likely causes:
- Fan motor connection line disconnection, miswiring, fan motor abnormalities, fan blade stalling.
Is it safe?
| Does the heat pump stop? | Yes |
|---|---|
| Engineer needed? | Yes |
The heat pump stops until the fault clears or is reset.
Resetting itself: unknown.
What you can check
- Note the code shown on the controller and the unit model numbers (on the rating plate label) before contacting your installer.
- Check the heat pump's breaker/isolator at the consumer unit is on; do not open any casing.
- Check the outdoor unit is not blocked by leaves, debris, snow or ice and that nothing is stored against the grilles.
- If the breaker or RCD trips repeatedly, leave the heat pump switched off and call an engineer; do not keep resetting it.
What the engineer will check
- Follow the manufacturer's troubleshooting flowchart for this code.
- Check fan for obstruction and free rotation (isolated).
- Check fan motor connector/wiring and drive board.
Who to ask for: Heat pump engineer.
Certification: Heat pump installer competence; F-gas / flammable-refrigerant (R290/R32) handling competence for any refrigerant-circuit work.
What you might notice
Sources
- Installation and service instructions - HPM08/10/12/14/16-Nd2 (Haier R290 monobloc) ↗ · page p.85 (printed; ManualsLib viewer p.91) · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026