F.070 on a Glow-worm GeniaAir: Invalid Device Specific Number (referenced with F.042: heat cell coding resistor not detected)
Short answer
On a Glow-worm heat pump, F.070 means: Invalid Device Specific Number (referenced with F.042: heat cell coding resistor not detected). The heat pump stops until the fault clears or is reset. An engineer is needed to fix the cause.
Reviewed 23 September 2026 · 1 source
What it means
The manual says: Invalid Device Specific Number (referenced with F.042: heat cell coding resistor not detected).
Part involved: Invalid Device Specific Number (referenced with F.042: heat cell coding resistor.
Likely causes:
- Heat cell/fan coding resistor not detected (listed only as a cross-reference under F.042).
Is it safe?
| Does the heat pump stop? | Yes |
|---|---|
| Severity | Fault — needs a manual reset once the cause is fixed |
| Engineer needed? | Yes |
The heat pump stops until the fault clears or is reset.
Resetting itself: no - the fault remains displayed until the cause is eliminated.
Manual reset: yes - after the cause is eliminated, press the reset button (indoor unit) or reset via the system control; if it recurs after several resets contact customer service.
What you can check
- Note the full code and text shown on the display (and the date/time it appeared). Check the heat pump supply breaker/isolator (and back-up heater breaker, if separate) at the consumer unit is on; if a breaker has tripped more than once, leave it off and call an engineer - do not open any casing. Glow-worm's MiPro Sense operating instructions say always contact your competent person in the event of a fault message; until they arrive you may select a limp-home (back-up heater) setting on the control, which is expensive to run.
What the engineer will check
- Check the coding resistor (PCB plug X25, contact 11/12).
Who to ask for: Heat pump/controls installer familiar with Vaillant eBUS controls.
Certification: MCS installer certification; Vaillant product training recommended.
What you might notice
Sources
- GeniaAir Appliance Interface installation and maintenance instructions ↗ · 8000043014_01 · page HPIM 7 8000043014_01 p.31 (mentioned under F.042) · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026