Heat pumps · Error codes · Dimplex
S13Dimplex · WPM heat pump manager platform (error-code grouping)
S13 on a Dimplex WPM heat pump manager platform: Domestic hot water reheating via the flange heater or pipe heater is active
Short answer
On a Dimplex heat pump, S13 means: Domestic hot water reheating via the flange heater or pipe heater is active. The heat pump keeps running with some functions stopped.
Reviewed 23 September 2026 · 1 source
What it means
The manual says: Domestic hot water reheating via the flange heater or pipe heater is active.
Is it safe?
| Does the heat pump stop? | Partly |
|---|---|
| Severity | Information only |
| Engineer needed? | No |
The heat pump keeps running with some functions stopped.
Resetting itself: Automatic.
What you can check
- No action - informational.
What the engineer will check
The manual does not list the engineer’s checks for this code.
What you might notice
Sources
- Dimplex WPM Touch heat pump manager - Operating instructions for users and specialists (Order no. 452117.66.02-EN, WPM3.13 / Display 1.15) ↗ · 452117.66.02-EN FD 0302 · page 56 · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026