C9 on a Daikin Altherma HT: Malfunction of thermistor (R4T) for return water thermistor (loose connection, disconnection, short circuit, failure)
Short answer
On a Daikin heat pump, C9 means: Malfunction of thermistor (R4T) for return water thermistor (loose connection, disconnection, short circuit, failure). The manual does not say whether the heat pump stops. An engineer is needed to fix the cause.
Reviewed 23 September 2026 · 1 source
What it means
The manual says: Malfunction of thermistor (R4T) for return water thermistor (loose connection, disconnection, short circuit, failure).
Part involved: thermistor / pressure sensor.
When it shows: When the return water temperature thermistor becomes disconnected or shorted while the unit is running.
Likely causes:
- Defect of indoor unit thermistor (R4T) for water return; Defect of indoor unit PC board (A1P).
Is it safe?
| Does the heat pump stop? | Not stated |
|---|---|
| Engineer needed? | Yes |
The manual does not say whether the heat pump stops.
Resetting itself: unknown.
What you can check
- Read the full error code shown on the user interface and note it, with the date/time, for your installer.
What the engineer will check
- Follow the service-manual troubleshooting flow chart for this code: check defect of indoor unit thermistor (R4T) for water return; check defect of indoor unit PC board (A1P).
Who to ask for: Heat pump engineer (Daikin-trained).
Certification: Electrical competence to BS 7671 for sensor/PCB wiring; F-gas if a refrigerant-side sensor must be replaced.
What you might notice
Sources
- Service Manual Daikin ALTHERMA HT ERSQ/ERRQ 011-016 AA V1/Y1 + EKHBRD (ESIE09-08C) ↗ · ESIE09-08C · page 156 · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026