H10.01 on a Baxi Assure Split ASHP: T Flow Zone A Closed Flow temperature sensor Zone A Closed
Short answer
On a Baxi heat pump, H10.01 means: T Flow Zone A Closed Flow temperature sensor Zone A Closed. The heat pump keeps running with some functions stopped. An engineer is needed to fix the cause.
Reviewed 23 September 2026 · 1 source
What it means
The manual says: T Flow Zone A Closed Flow temperature sensor Zone A Closed.
Part involved: temperature sensor.
Is it safe?
| Does the heat pump stop? | Partly |
|---|---|
| Severity | Fault — clears by itself when the condition goes |
| Engineer needed? | Yes |
The heat pump keeps running with some functions stopped.
Resetting itself: yes - system restarts automatically when the cause disappears (may run in degraded/back-up mode meanwhile).
Manual reset: not required once cause removed.
What you can check
- Note the exact code shown on the controller and when it appeared.
- The manual's user steps allow switching the system off and on once to see if the error clears; if the code returns, contact the installer.
- If the code persists or returns, contact a heat pump engineer.
What the engineer will check
- Diagnose per manufacturer service procedure (manual gives description only).
Who to ask for: heat pump engineer (controls / sensors).
Certification: Manufacturer-trained heat pump engineer.
What you might notice
Sources
- Installation and Service Manual - Air/water 'Split Inverter' heat pump Baxi Assure, Assure AWHP-IDU 4-8 E ↗ · 7762758 - v05 - 19082020 · page 92 · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026