Heat pumps · Error codes · Atlantic
ODU3-22FAtlantic
ODU3-22F on an Atlantic heat pump: Hydraulic unit abnormality condition
Short answer
On an Atlantic heat pump, ODU3-22F means: Hydraulic unit abnormality condition. The heat pump stops until the fault clears or is reset. An engineer is needed to fix the cause. The wording differs by model range — each is shown below.
Reviewed 23 September 2026 · 2 sources
What it means
On the Alféa Excellia / Excellia Duo (R410A split, 11-16, pre-A.I.)
The manual says: Hydraulic unit abnormality condition.
Likely causes:
- Communication/connection fault between hydraulic unit and outdoor unit (or between boards), or incompatible combination.
On the Alféa Hybrid Duo (heat pump + integrated fuel-oil boiler)
The manual says: Hydraulic module anomaly.
Likely causes:
- Communication/connection fault between hydraulic unit and outdoor unit (or between boards), or incompatible combination.
Is it safe?
| Does the heat pump stop? | Yes |
|---|---|
| Severity | Fault — clears by itself when the condition goes |
| Engineer needed? | Yes |
The heat pump stops until the fault clears or is reset.
What you can check
- Check the heat pump isolator and consumer-unit breakers are on (do not open any casing).
- Note the error number/LED pattern shown and give it to your installer.
What the engineer will check
- Check interconnection cable and terminals between indoor and outdoor units.
- Check board connectors and unit combination.
Who to ask for: heat pump / electrical.
Sources
- alféa excellia duo Maintenance Document (U0546279_1738_EN_16) ↗ · U0546279_1738_EN_16 · page 73 · Reviewed 23 September 2026
- alféa hybrid duo Installation and commissioning instructions (doc 1440-13) ↗ · 1440-13 · page 67 · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026