Heat pumps · Error codes · Warmflow
E203Warmflow · Zeno A-Series air source heat pump (R32) AS01-R32/AS02-R32/AS03-R32
E203 on a Warmflow Zeno A-Series air source heat pump AS01-R32/AS02-R32/AS03-R32: Fan Motor 2 Overload
Short answer
On a Warmflow heat pump, E203 means: Fan Motor 2 Overload. The heat pump stops until the fault clears or is reset. An engineer is needed to fix the cause.
Reviewed 23 September 2026 · 1 source
What it means
The manual says: Fan Motor 2 Overload.
Part involved: DC fan motor / fan driver board.
Likely causes:
- The Fan Motor 2 is overloaded.
Is it safe?
| Does the heat pump stop? | Yes |
|---|---|
| Engineer needed? | Yes |
The heat pump stops until the fault clears or is reset.
What you can check
- Note the exact code shown on the controller (a photo helps) and report it to your installer or the manufacturer's service line.
- Check the heat pump's supply breaker/isolator at the consumer unit is on (do not open any casing).
- Check the outdoor unit grille/coil is not blocked by leaves, debris or snow (do not open the casing).
What the engineer will check
- Check the operation of the fan.
Who to ask for: heat pump electrical.
Certification: Electrical competence for work inside the outdoor unit.
What you might notice
What owners and engineers report
1 owner and engineer report mentions this.
- No heating on the Zeno A-Series air source heat pump (R32) AS01-R32/AS02-R32/AS03-R32: 1 report
Sources
- Warmflow High Efficiency Variable Speed Air Source Heat Pumps A-Series AS01-R32 / AS02-R32 / AS03-R32 - User, Installation & Service Instructions (9007723 Issue C) ↗ · 9007723 Issue C · page 57 · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026